Ok it’s been a while since i last posted but thats just cause i’ve been slack when it comes to updating the webpage. Anyway i’m still in the body panel process at the moment and have just primered one of the side panels The primer i used is part of the stuff i just bought […]

Now i’ve tack welded bits of thin panel steel to the frame work of the first side panel and ready to start adding the body filler It’s a bit clearer now that there is a scoop in the middle of the guard to direct air flow to the radiator side view of the overall body […]

I was going to make a fibreglass panel for the rear as well but i think diamond plate does just as good a job here and it’s quicker. Made a start on the new side panel and once again i’m making up a metal skeleton and then covering it with scrap panel steel then body […]

I decided to stop making the original side panel cause i didn’t like it and made a start on the plug for the bonnet instead I can’t draw very well and it’s too much hassle to draw up the body panels on the computer so i’m designing the bonnet as i go along. There are […]

I’ve only started on the bogging of the panel so there is alot more to go but what i have also done is cut out a triangluar shaped scoop in the panel which will end up being a air vent that feeds the radiator. Here i’ve put it back on the trike just to gain […]

The weather is getting better now so while i wait for the fork tubes to turn up i made a start on playing with some ideas for making the body panels. The concept is to end up with a fiberglass panel either side of the seat that curves up towards the top of the radiator […]