– View the Trike Build – – View the Hover Build – – I’m empty – Duct Area 4 – This is one of my air diverter panels finally put in place. The panels i fitted here are in a V shape and go from the rear corners of the cockpit to the center, i […]
Duct Area 3View the Trike buildI have now fibre glassed the rear duct panels with two layers of glass on the inside seams and one layer on the outside seams. I have also cut the hole in the duct where the splitter plate will go. The splitter plate is currently still left off cause i […]
Duct Area 2View the Trike buildThe rear panel that I’m going with is not what the superwedge usually has and like i said earlier it’s cause i have to allow for the full sized rudders, so what i’m making here is a flat panel that is supported by several legs that i have glued in…
Wooo hoo i got my duct and its a sexy looking beast hehehe. After talking to my duct supplier i found out that the duct has reinforcement through it and that cutting the duct prior to adding the splitter plate is ok, so i did 🙂 and now its sitting down in place. Just playing […]