Chassis 7
Pictured here is the upper rear shockie mounts that i've made up out of a mixture of 3mm box tubing and 4mm plate, currently tacked in place ready for Charlie to TIG weld.

Chassis 7

I've cut up some 3mm plate to fit between the seat framing and the lower pipes so that both items are locked solid together, i've cut ( and yet to…

Continue Reading Chassis 7
Chassis 6
Here we have a close up of the steering neck and i got to say that notching these pipes to meet up with the neck was a complete pain just because there are like 3 or so different angles to take into acount, anyway its all done now so i'm happy again.

Chassis 6

Here we have a close up of the steering neck and i got to say that notching these pipes to meet up with the neck was a complete pain just…

Continue Reading Chassis 6
Chassis 5
Now that the steering neck is mounted in place i temporarly mounted the front forks and wheels just so i can visualise the overall shape of the trike, so i took a photo and photoshopped a couple bits and peices just to get a general idea.

Chassis 5

Now that the steering neck is mounted in place i temporarly mounted the front forks and wheels just so i can visualise the overall shape of the trike, so i…

Continue Reading Chassis 5
Chassis 4
I drew a centre line down the middle of the frame jig and used a laser level, plumbob, bubble level, angle meter and a tape measure to align the neck into position. I welded an old RN250 lower triple tree that i picked up for $1 into position on the box section that i'm using for supporting the steering neck that way i dont have to make up bolts and spacers etc to hold the neck all i have to do is slip the neck over the triple tree.

Chassis 4

The steering neck is all made up and ready to be fitted so i sat in the drivers seat and worked out how high i want the steering so that…

Continue Reading Chassis 4
Chassis 3
I bought a complete front end off a CBX 750 which comes with handlebars, light switches and ignition etc and the front forks but best of all a 16inch front wheel with twin disc brakes. I will be eventually removing the forks and making up a leading link front end with extended forks but for now i have it sitting in place on approximately a 45 degree angle so i can geta visual of things

Chassis 3

I bought a complete front end off a CBX 750 which comes with handlebars, light switches and ignition etc and the front forks but best of all a 16inch front…

Continue Reading Chassis 3
Chassis 2
The main pipe on either side of the trike that goes from the rear of the trike to the front has now been bent and welded up. I've also made the side plates that support the top suspension arms have currently bolted them in place so that i can take them on and off as needed, eventually they will be welded on permantely. Now that the plate is attached i have mounted the top suspension arms and as you can tell from this photo the wheels are sitting pretty damn good :-)

Chassis 2

Ok so here i'm making a template up for the panel that the top arm and top shockie mount will mount to. Once the templates are made i will be…

Continue Reading Chassis 2