November the 2nd 2008 -I picked up another car cheaper than it would of cost me in parts to fix the knock in the old motor. So I swapped motors…
At long last the trike is %98 finished. The %2 left is small things like upholster the arm rest's and make engine cover and get it complied, get a VIN…
2.5 litres of Honda 5 cylinder, fuel injected power heheThink i might change that cross bar over the top of the engine yet, havent made my mind up on that…
%95 of the fabrication is done now and just waiting on certification so i can pull it all down and tidy everything up then paint it. I had previously made…
I took the trike for a spin with a new tyre on the front and it flicks stones etc everywhere so i had to extend the front guard. Here is…
Ok so it's been like moons since i got around to adding to the web page but i'm finally adding some more pics now. I bought two trailer guards and…
I've now made up a metal dash unit and made a start on panelbeating the harley tank. Yes im getting sick of sanding but sadly when i wake up in…
I Know this page shows various views of the same panel but i couldn't help adding them cause i was quite happy with how it turned out considering this is…
At last I'm finally starting to make a actual part from a mould. This is the front panel just freshly fiberglassed with 3 layers of 450GSM matt And here is…
I should of documented a bit better the process of making this mould but i wasn't sure how it would turn out so hopefully i will document the process better…